Contents: 1 Cartridge holder, 1 screwdriver, 1 needles, 1 ink syringe(20ml)

Using steps:

1) Put the cartridge unto the cartridge holder with the flange facing inward see fig 1

2) Use the screwdriver to enlarge the small hole on the cap and make sure it is large enough to insert the needle see fig 2

4) Substitute the sealing cap of the syringe with the needle, take off the cap of the needle and insert the needle deep into the cartridge, then depress the plunger slowly until the cartridge is full (about 12, 15ml) and take down the syringe afterwards. see fig 3, 4, 5.

4) Take the cartridge out of the holder, clean the nozzle with tissue paper, then reload the cartridge into the printer and run the head cleaning utility 2-3 times before printing test or nozzle test.

Notice:

Make sure that the ink in the cartridge has already run out, although no completely, before refilling.

Printing results will be affected if the cartridge dries or is damaged.  If printing results do not become normal even after step 4 is repeated for several times, leave the cartridge in the holder or the printer overnight before performing printing test or nozzle test again.  If it still remains abnormal, the print head is already damaged and cartridge will have to be replaced.

* Note: Set of instructions similar to one above will be included with your order.

Cartridge Holder, Mini-Screwdrivers, Needle, Syringe with Ink.

[Figures 1 & 2]

[Figures 3 & 4]

[Figure 5]